Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateTrusted Garage Door Spring Repair for Longmont Homeowners
When a garage door spring lets go, the door usually won’t open, and if it’s hanging open, your house is exposed until it’s fixed. A snapped torsion or extension spring isn’t something to work around with a pry bar or a helper – those springs hold hundreds of pounds of tension, and they can hurt you badly if they’re handled wrong. Our technicians have up to 15 years of experience with exactly this kind of failure, and we carry the springs, cables and winding tools to get the door balanced and running on the same visit whenever the parts match. We service Longmont homes daily and offer same-day spring repair when you call before the day fills up. Call (888) 574-5680. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
What Our Garage Door Spring Repair Service Includes
Spring work covers more than swapping a coil. We look at the whole lifting system – springs, cables, drums, bearings, rollers and the opener’s relationship to all of it – because a spring that fails early usually has a tired partner somewhere in the same assembly. Here’s what each part of the job looks like.
Torsion Spring Replacement
Torsion springs sit on a shaft above the door and do the heavy lifting through cables and drums. They’re the most common spring type on newer Longmont builds, and when one breaks you’ll usually hear a loud bang and find the door dead weight. We measure the old spring’s wire size, inside diameter and length, then wind a matched replacement to the correct turns and test the door’s balance before we leave.
Extension Spring Replacement
Extension springs run along the horizontal tracks on each side and stretch to lift the door. Older Longmont homes often still have them, and they’re the type that can fly if a cable snaps without a safety restraint in place. We replace them in matched pairs and confirm the door closes evenly with no slack on either side.
Broken Spring Repair
A broken spring is the call we get most. You’ll know because the door feels unusually heavy, the opener strains or quits, or you can see a visible gap in the coil. We confirm the break, check whether the second spring is close to failing, and give you a written price for the single spring or the pair before anything is taken apart.
Spring Adjustment
Sometimes the spring is intact but the door is out of balance – it drifts down on its own, slams at the bottom, or the opener has to push hard to get it moving. Adjustment means resetting the tension to match the door’s actual weight. We check balance at the halfway point and fine-tune until the door holds position on its own.
Safety Cable Installation
Safety cables run through the center of extension springs so a broken spring stays contained instead of becoming a projectile. If your door has extension springs and no cables threaded through them, that’s a real gap worth closing. We install cables rated for the door’s weight and route them correctly through the spring and track bracket.
Spring Inspection
An inspection is the low-cost way to find out whether you have a spring problem coming. We look for gaps, rust at the coil, stretched extension springs, frayed cables and uneven wear between a pair. If everything checks out, we tell you that and you’re done – no pressure to replace anything that’s still doing its job.
Styles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
Brands We Service for Garage Door Spring Repair
Springs are springs in principle, but the door they lift isn’t. LiftMaster and Chamberlain openers – the two most common smart-opener platforms we see in Longmont – have specific force and travel settings that have to be right once a new spring changes how the door moves. We reset those limits as part of the job rather than leaving the opener to fight a door it isn’t calibrated for. On the door side, Clopay and Genie systems show up often too, and we know where their hardware tends to wear: Clopay doors have their own drum and cable configuration, and Genie opener rails and force settings need a different touch than LiftMaster units.
We also work on the older stuff. Craftsman and Raynor assemblies from earlier decades are still common in Longmont, and the right spring for those doors is a measurement question, not a guess. Whether you have LiftMaster, Chamberlain, Genie, Clopay or any other make, we can help – and if we need a part that isn’t on the truck, we tell you that upfront instead of improvising.
Signs You Need Garage Door Spring Repair Right Now
- A loud bang from the garage. That sound is usually a torsion spring snapping under tension. The door won’t lift after that, and forcing it with the opener can burn out the motor or bend the door panels.
- The door feels extremely heavy when you lift it by hand. A balanced door takes light effort. If you’re putting your shoulder into it, the spring is either broken or badly out of adjustment – stop lifting and call.
- A visible gap in the spring coil. On a torsion spring, look along the coil above the door. A clean break shows as a two-inch gap. On extension springs, look for a stretched-out section that no longer recoils.
- The door drifts down or slams shut. A door that won’t hold position halfway up has lost tension. That’s a spring adjustment issue, and it puts wear on the opener every single cycle.
- The opener strains, hums, or quits mid-travel. The opener is often the messenger, not the problem. If it’s straining, the spring likely isn’t carrying the door’s weight anymore, and continuing to run it shortens the opener’s life.
Our Garage Door Spring Repair Process – Step by Step
- 1
Phone diagnosis and scheduling. We ask what the door is doing – sound, weight, visible break – so we know which springs and tools to bring. You get a clear arrival window and a straight answer about whether it’s a same-day job.
- 2
On-site safety check and full inspection. Before touching anything, we secure the door, check the cables and drums, and look at both springs. We’re checking for the second failure that often follows the first.
- 3
Written estimate, agreed before work. You get the price in writing – spring, labor, and any cable or hardware that has to go with it. Nothing starts until you say go, and the written estimate is what you pay.
- 4
Spring replacement and calibration. We wind the new spring to the correct turns, replace matched pairs together, and reset the opener’s force and travel limits if it’s a LiftMaster or Chamberlain unit. Then we cycle the door several times and check balance at the halfway point.
- 5
Final test and walkthrough. We run the door through full open and close cycles, check the safety reverse, and show you what was replaced. If anything else is close to failing, we point it out without pressure – you decide what happens next.
See the difference
Before
After
Before
After
Before
AfterHow Much Does Garage Door Spring Repair Cost in Longmont?
A typical garage door spring repair in Longmont runs $180 – $340 for one spring, depending on the spring type, wire size and whether cables or drums need attention at the same time. Since springs are usually replaced as a matched pair, a pair typically costs about twice that range – roughly $360 – $680. Cable repair, when a frayed cable goes with the spring, runs $130 – $250. If the opener was damaged by running against a dead door, opener repair runs $120 – $320.
What moves the price: torsion versus extension springs, door weight and height, whether the second spring is also due, and whether rust has seized the drums or bearings. What doesn’t move it: the time of day you call. The price is set per job by the written estimate, and we quote it before any work starts – so there’s no surprise on the invoice.
To avoid overpaying, ask for the price on one spring and on the pair, and ask whether cables and rollers are included or extra. Our estimates are free. Call (888) 574-5680 for an exact quote.
Garage Door Spring Repair Near Longmont – Our Service Area
We handle spring repair across Longmont and the surrounding towns – Frederick, Firestone, Erie, Dacono, Lafayette, Boulder, Louisville, Broomfield, Fort Lupton, Superior and Northglenn. Most calls in Longmont and the closer towns get same-day attention when you call early, and we’ll give you a realistic window rather than an optimistic one. For spring work in the northern towns, see our garage door spring repair page, and for Frederick-area calls, garage door spring repair there covers the local details.
Serving Longmont, CO – Our Local Coverage Area
We serve Longmont and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Garage Door Spring Repair in Longmont
Garage door spring repair is the replacement or adjustment of the torsion or extension springs that counterbalance your door’s weight. Without a working spring, the opener is lifting the entire door on its own, which it isn’t built to do. The job includes measuring the spring, installing a matched replacement, and recalibrating the door and opener so everything moves together. Call (888) 574-5680 if your door has gone heavy or stopped lifting.
Most single-spring replacements take about an hour to 90 minutes once we’re on site, and a matched pair takes a bit longer. Add time if cables, drums or bearings need work, or if the opener has to be recalibrated after. We give you a realistic time estimate when you book, and same-day service is often available in Longmont. Call (888) 574-5680 to check today’s schedule.
A typical spring repair in Longmont runs $180 – $340 for one spring, and about double that for a matched pair since pairs are usually replaced together. Cable repair, if needed, runs $130 – $250. The written estimate sets the final price, and it’s agreed before any work starts. Call (888) 574-5680 for an exact quote – estimates are free.
Yes. We work on LiftMaster and Chamberlain openers, including the myQ smart-home platform, and we reset force and travel limits as part of a spring job. We also service Genie, Clopay, Amarr, Wayne Dalton, Craftsman and Raynor equipment. If your opener is older or a brand we haven’t listed, tell us the model when you call and we’ll confirm before we come out.
Same-day spring repair is often available in Longmont when you call before the day fills up. We answer 24/7, and fast dispatch runs from 7am to 7pm, Sunday through Friday. We’re closed Saturday, so a call that comes in then gets booked into the next opening. Call (888) 574-5680 and we’ll give you a real window.
Yes – our spring replacements are backed by a satisfaction guarantee, and the warranty terms for the specific spring and hardware are written on your estimate. We walk you through what’s covered before we start so there’s no confusion later. If something isn’t right after the repair, call us and we’ll come back out.
Clear the floor under the door and the path to the garage so the technician has room to work safely. Don’t try to open or close the door yourself – a door with a broken spring can come down hard. If the door is stuck open, keep people and pets away from it until we arrive. When you call, have the door’s brand and approximate age ready if you know them.
Schedule Your Garage Door Spring Repair Service in Longmont Today
A broken spring leaves your door unusable and, if it’s open, your home exposed. Call (888) 574-5680 and we’ll get a technician out with the right spring for your door. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. Estimates are free, the price is agreed before work starts, and the written estimate is what you pay. For broader door issues, start at Longmont Garage Door Repair Pros.
Written by the team at Longmont Garage Door Repair Pros.